EPANET Tutorial 02 09 – Running a Water Quality Analysis | Hydraulic Modeling


Check out our blog post that goes along with this video

EPANET Running a Water Quality Analysis

Click here to watch a playlist of all our training videos:

Steps to running a water quality analysis in EPANET:

Set Quality Options in the Data Browser to Chemical, Trace or Age. To analyze chemical breakdown such as chlorine, type the chemical directly into the box and it will be saved.
If you are analyzing a chemical such as chlorine, you need to enter the decay coefficients into the Reactions Options. You will also need to set some Initial Quality values at key locations in your network such as at a reservoir representing a water treatment plant clearwell. The initial quality will be the constant level of concentration that the constituent leaves the clearwell.

Tips:

The length of the simulation must be long enough for periodic results to appear.
For water quality models to give good results, they often require a higher level of calibration than a planning level model.

Contact Us

Additional resources:
http://www2.epa.gov/water-research/epanet
https://en.wikipedia.org/wiki/EPANET

Written By Haterrovat1982